Why Won’t My Dryer Start?

ou go downstairs to finish drying your laundry, and now your dryer won’t start! Well, I’ve created a step-by-step guide on how to troubleshoot your appliance. Hopefully this guide will help identify your problem without having to hire a repair man. The only tools you’ll need are: ohm/volt meter, and a screwdriver.

Okay, so the first step is to check your circuit breaker box and check to make sure a fuse hasn’t blown. Your next step is to check if your dryer is plugged into the wall. (Yes, it does sound stupid, but it has happened before!) You should also check to make sure your outlet is receiving power. Just plug in a lamp or something to check for power. Inspect the dryer cord to see if it has any burn marks, because a faulty cord could be why your dryer won’t start. If you’re still asking yourself “why won’t my dryer start?” then you should follow the next steps on testing the machine’s inner components Dryer Repair Los Angeles.

First and foremost, make sure your dryer is unplugged from the wall outlet before you start testing parts. Serious injury to both you and your appliance could result if you don’t. Here’s where your tools will come in handy. The next thing to check is your door switch, if this switch is no good your dryer will think that its door is open and it won’t start. This part is located near the front panel of the door. To test it you’ll need to remove it from the machine and test for continuity with your meter. If it tests bad, replace it. If doing that doesn’t solve your problem, move on to step three.

The third thing to test is your start switch, which is located underneath the control panel. You will need to remove the end caps from the sides of the panel and also remove the screws. Flip the panel over to get to your start switch. Once you have the switch, test it with your meter. If it tests as good, move on to the next step. If it is bad then you most likely just figured out why your dryer won’t start; replace the part and you’ll be ready to dry clothes again.

Now, you’ve tested everything on the front of the machine that could be your problem. The next step is to move to the back of your dryer for further troubleshooting. Use your screwdriver and remove the screws on the back panel, take off the back panel and set it aside. (With most models you can open up the back panel this way, but some are different. Refer to your owner’s manual for a diagram of how yours opens up.) Now that you have the back panel off the dryer, the first thing you’ll want to check is the thermal fuse. The thermal fuse is located near the exhaust vent; this fuse is triggered to blow if your dryer overheats. Test this small part using your ohm meter; if it tests badly you should replace both your thermal fuse and the thermostat. You should also test your dryer thermostat for continuity using your ohm meter. If both test bad, get them replaced. If they are both good then move to the next step.

If you’ve gotten this far and you are still asking yourself, “why won’t my dryer start?” it might be a smart move to call a repairman. But if you are a do-it-yourselfer, and you don’t mind testing some tricky parts you could probably figure it out. Dryer timers are very rarely the cause of the dryer not starting. Even so, you can test the timer to see if it tests for continuity. If that doesn’t work you should test the motor, if your motor is burned out that may be a reason why your dryer won’t start.

 

Leave a Reply

Your email address will not be published. Required fields are marked *